PC BazĂˇrek

ZĂˇkladnĂ deska HP ASUS P5BW-LA, soc.775 s velkou vĂ˝bavou + vĂ˝konnĂ˝ chladiÄŤ v hodnotÄ› 400kÄŤ

Motherboard description

Manufacturer's motherboard name: ASUS P5BW-LA
HP/Compaq name: Basswood2-UL8E

Form Factor

Micro-ATX: 24.4 cm (9.6 inches) x 24.4 cm (9.6 inches)

Chipset

Northbridge: Intel P965
Southbridge: ICH8DH

Front-side bus speed

533 MHz, 800 MHz, 1066 MHz (processor dependent)

Processor upgrade information

Socket type: 775

Motherboard supports the following processor upgrades:

Intel Core 2 Duo Processor E4x00 with Dual Core Technology (Conroe)
Intel Core 2 Duo Processor E6x00 with Dual Core Technology (Conroe)

Memory upgrade information

Dual channel memory architecture
Four 240-pin DDR2 DIMM sockets
Supports PC2 4200 (533 MHz), PC2 5300 (667 MHz) and PC2 6400 (800 MHz) DDR2 DIMMs
supports 2GB DDR2 DIMMs
Supports up to 8 GB on 64 bit PCs
Supports up to 4 GB* on 32 bit PCs

NOTE:

*Actual available memory may be less

Video

Does not have integrated graphics

Motherboard does not contain onboard graphics hardware to display video. A video card must be installed.

Audio

Integrated Realtek ALC885 Audio

High Definition 8 channel audio
Supports SPDIF input/output
Audio CODEC: Realtek ALC885

Network

LAN: 10-Base-T

Interface: Integrated into motherboard
Technology: Intel 82562V
Data transfer speeds: up to 10/100 Mb/s
Transmission standards: 10-Base-T Ethernet

Expansion Slots

One PCI Express x16
Three PCI
Two additional PCI when using an optional PCI extender card. This requires a full sized ATX case.

I/O Ports

Back I/O ports

Figure 2: Back I/O panel

1 - PS/2 mouse (green)

2 - Coaxial SPDIF Out

3 - RJ-45 Network (LAN)

4 - Audio: Rear Speaker Out (black)

5 - Audio: Center/Subwoofer (yellow orange)

6 - Audio: Line In (light blue)

7 - Audio: Line Out (lime)

8 - Audio: Microphone (pink)

9 - Audio: Side Speaker Out (gray)

10 - USB 2.0: 4

11 - IEEE 1394a (fireWire)

12 - Coaxial SPDIF In

13 - PS/2 keyboard (purple

Internal Connectors

One 24-pin ATX power connector
One 4-pin ATX power connector
Six SATA connectors
One floppy drive connector
Two 12v fan connector
One 9-pin header for power button, reset button, power LED, and HDD LED
One SPDIF-Audio output connector
One Line input connector (interrupts line input on back panel, Vista capable, requires matching front audio jack module)
One 9-pin audio header for headphone-out and microphone-in (yellow, Vista capable, requires matching front audio jack module)
Three USB 2.0 headers supporting 6 USB ports or devices
One IEEE 1394a header
One jumper for resetting BIOS settings
One jumper to disable BIOS password checking
One additional jumper labeled J6. Do not change.
One additional header labeled "SPI_HEADER". Do not change.

Motherboard layout and photos

Figure 3: layout

Clearing the BIOS settings

CAUTION:

Do not change any jumper setting while the computer is on. Damage to the motherboard can result.

This motherboard has jumpers to clear the Real Time Clock (RTC) RAM in CMOS. In the default (normal) position the jumper is on pins 2-3.

Figure 4: Jumper locations

Clearing CMOS

To clear CMOS, follow these steps:

Temporarily set jumper CLEAR_CMOS to pins 1-2.
Wait 5-10 seconds and then return the jumper to pins 2-3.
On the next PC startup, enter BIOS setup to reset any custom BIOS settings.

Clearing the BIOS password

The BIOS password is used to protect BIOS settings from unwanted changes. If the BIOS password has been forgotten, disable password checking to enter setup and change or erase the password.

To erase the BIOS password follow these steps:

Turn OFF the computer and unplug the power cord.
Locate the jumper labeled CLEAR_PWD. In the default (normal) position the jumper is on pins 2-3.
Move the jumper on jumper CLEAR_PWD to pins 1-2 to clear password.
Plug the power cord and turn ON the computer.
Hold down the F1 key during the startup process and enter BIOS setup to change or clear the password.
After changing or clearing the BIOS passwords, remember to reset the jumper to pins 2-3.

Additional jumpers

The motherboard may include an additional jumper J6. This jumper will have pins 1-2 bridged and should not be changed.

The motherboard may include a header labeled "SPI_HEADER". This header will have pins 1-2 jumpered and should not be changed.

999.00KÄŤ

Nákupní košík : 0 položek

Nákupní košík :
0 položek